Home / Services / Marine electronics install
Lake St. Clair · Detroit River
Marine electronics install and repair
Chartplotter and MFD installs, AIS, autopilot setup and engine data over NMEA 2000. Brad wires it at your slip and confirms it works before he leaves.
Emergency service, 24/7: call or text 262-300-7729.
What marine electronics install covers
- Chartplotter and multifunction display installation
- AIS installation and network integration
- Autopilot installation and calibration, including chasing calibration faults
- Engine-data gateways that put engine RPM, temperature and fuel data onto a NMEA 2000 network
- NMEA 2000 backbone build-out, termination and troubleshooting for missing or dropping data
The $150 visit fee is credited to the job. You get the price in writing before any work starts.
Garmin, Simrad, Raymarine and similar
Brad installs and services multifunction displays, AIS and autopilot systems from Garmin, Simrad, Raymarine and similar makers. Every maker has its own install manual for wiring, mounting and network setup, so the exact steps and settings come from that manual rather than a generic install sheet.
Engine data on the chartplotter
A lot of engines can put their RPM, temperature, trim and fuel-flow data onto the boat's NMEA 2000 network through an engine-data gateway, so it displays right on the chartplotter alongside GPS and other instruments instead of living only on the engine's own gauges. Brad confirms the gateway generation matches the engine before ordering parts, since not every engine and gateway combination is interchangeable.
Most "missing data" faults are the network, not the device. A NMEA 2000 backbone needs exactly two terminators, one power feed, and solid connections at every T. Missing or extra terminators, a loose drop, or a voltage-starved backbone cause far more no-data complaints than an actual failed instrument.
Autopilot calibration faults
An autopilot that throws a calibration or setup fault is usually asking for the calibration sequence to be run correctly, whether that's a compass, rudder-reference or drive calibration, rather than pointing to a failed part. Brad works through the maker's calibration procedure in order rather than guessing at which step is wrong.
Where Brad installs marine electronics
Common questions
Can you get my engine data showing on my chartplotter?
Yes. Many outboard and inboard engine systems can feed RPM, temperature and fuel data onto a NMEA 2000 network through an engine-data gateway, so it shows up on the chartplotter alongside GPS and other instruments.
What brands do you install?
Garmin, Simrad, Raymarine and similar multifunction display and autopilot brands. Brad works from each maker's own install documentation for the specific model.
My autopilot throws a calibration fault, can that be fixed at the dock?
Often, yes. Calibration faults are usually a setup, sensor or network issue rather than a failed part, and re-running the calibration procedure correctly resolves a lot of them.
My MFD shows no data from one device, where do you start?
The network itself: termination, power and connections at the T-connectors, before assuming the device is bad. Most missing-data faults on a NMEA 2000 network trace back to the physical network, not the instrument.
Power or charging issue on the same boat? See marine electrical or the boat battery not charging guide.
New electronics, or a network acting up
Text a photo of the helm and the model of what you have, or want.
