Home / Services / Sailboat engine repair
Lake St. Clair · St. Clair River
Sailboat auxiliary engine repair
Yanmar, Universal and Westerbeke diesels, and the Atomic 4 gas auxiliary. Brad works on the engine at your slip, cooling, fuel and drivetrain included.
Emergency service, 24/7: call or text 262-300-7729.
What sailboat engine repair covers
- Overheating diagnosis on the raw-water side: impeller, strainer and mixing elbow
- Fuel system troubleshooting: air in the line, water and contamination, filter service and bleeding
- Injection pump and injector issues on diesel auxiliaries
- Shaft alignment and cutless bearing wear behind the engine
- Weak-start diagnosis: glow plugs, batteries, cables and compression on diesels
- Atomic 4 gas auxiliary service: ignition, carburetion and fuel
The $150 visit fee is credited to the job. You get the price in writing before any work starts.
Small marine diesels live and die by cooling and fuel
Yanmar, Universal and Westerbeke auxiliaries are marinized industrial diesel blocks, usually running closed cooling with a heat exchanger and a raw-water loop. Almost all of the trouble on these engines traces back to one of two places: the raw-water cooling path, or the fuel system. A worn impeller, a blocked strainer or intake, or a corroded mixing elbow are the classic overheating causes. On the fuel side, air in the line, water or debris in the tank, and a clogged filter are the usual reasons an engine is hard to start or runs rough, and diesel fuel systems need to be bled once air gets in or a filter is changed.
Clean, water-free fuel is everything on a diesel. The injection pump and injectors depend on fuel that's free of water and debris. Chasing a fuel-related no-start or rough-run issue starts at the tank and filters, not at the injection pump itself.
The Atomic 4 is still out there
Plenty of older sailboats still run the Atomic 4, a gas inboard auxiliary that predates the small diesels that eventually replaced it on most boats. It has its own ignition and carburetion to keep in tune, and its own set of common wear points, different from a diesel's fuel and cooling concerns.
Vibration usually means the drivetrain, not the engine
A shaft that's out of alignment, or a cutless bearing worn enough to let the shaft move around in it, shows up as vibration under way, sometimes mistaken for an engine problem. Brad checks alignment and cutless bearing play as part of a sailboat engine visit rather than assuming vibration means the engine itself is at fault.
Where Brad works on sailboat auxiliaries
Common questions
What sailboat auxiliaries do you work on?
Yanmar, Universal and Westerbeke marine diesels, and the older Atomic 4 gas auxiliary still found on a lot of classic sailboats.
My diesel is overheating, where do you look first?
The raw-water side: the impeller, the strainer for a blockage, and the mixing elbow, which corrodes and restricts flow on small marine diesels over time. Most overheating traces back to something in that path rather than the closed coolant side.
My engine is hard to start, or runs rough, could that be the fuel?
Very often, yes, on a diesel. Air in the fuel system, water or contamination in the tank, and clogged filters are common causes of hard starting and rough or surging running, and the fix usually starts with the fuel system and a bleed rather than the injection pump.
Do you do shaft alignment and cutless bearing work?
Yes. Vibration is the usual sign of a misaligned shaft or a worn cutless bearing, and both are checked and corrected as part of the drivetrain work behind a sailboat auxiliary.
Engine won't start at all? See boat won't start. Heading into winter? See boat winterization.
Diesel or auxiliary acting up
Text a photo of the engine and describe exactly what it's doing.
