Home / Services / Steering and controls repair
Lake St. Clair · Detroit River
Steering and controls repair at your slip
Shift, throttle and steering cables, hydraulic steering leaks and bleeding, and drives that won't shift right. Brad works through it at the boat instead of pulling the whole helm.
Emergency service, 24/7: call or text 262-300-7729.
What steering and controls repair covers
- Shift and throttle cable adjustment and replacement
- Mechanical steering cable service, including a stiff or seized cable
- Hydraulic steering leak diagnosis, fluid top-up and system bleeding
- Drive shifting problems, including hard shifts and won't-shift-into-gear complaints
- Helm pump, cylinder and steering ram inspection
The $150 visit fee is credited to the job. You get the price in writing before any work starts.
Spongy steering is often air
Hydraulic steering runs on fluid, and if the wheel feels spongy, loose, or takes more turns than it used to, air has gotten into the system somewhere. Brad looks for the leak first, since bleeding the air out without fixing the leak just brings the air back. The system takes the maker's specified fluid only; mixing in the wrong fluid damages seals.
Shifting problems can be the cable or the drive
A drive that won't shift cleanly into gear, clunks going into gear, or resists shifting at all can be a worn or misadjusted shift cable, or a problem in the shift mechanism inside the drive itself. Brad checks the cable, its linkage and adjustment before opening up the drive, since the cable is the simpler and more common fault.
Mechanical and hydraulic steering fail differently. Mechanical cable steering gets stiff or seizes as the cable corrodes internally. Hydraulic steering goes spongy or loose from air and leaks. Knowing which system is on the boat changes where Brad starts looking.
Power trim and tilt use their own hydraulic system
Trim and tilt run on a separate pump, reservoir and cylinders from the main steering, with their own fluid. A trim that won't move, or drifts down on its own, points to that pump, its solenoid, the fluid level, or a leaking cylinder rather than the steering system itself.
Where Brad does steering and controls work
Common questions
My steering feels spongy or loose, what does that mean?
On hydraulic steering, spongy or loose steering almost always means air has gotten into the system, usually from a leak somewhere in the lines or at the helm pump or cylinder. Brad finds the leak first, then bleeds the system.
My drive won't shift into gear, or shifts hard, is that the cables or the drive itself?
It can be either. A worn or seized shift cable is a common cause, but the shift mechanism inside the drive itself can also be the problem, so Brad checks the cable and linkage before assuming the drive needs to come apart.
Can you bleed hydraulic steering without pulling the helm apart?
Yes, bleeding is done through the system's own fill and bleed points, not by disassembling the helm. Finding and fixing the leak that let air in is the other half of the job.
Do you work on mechanical cable steering too, not just hydraulic?
Yes. Older or smaller boats often use mechanical cable steering, which fails differently than hydraulic, usually from a stiff or seized cable rather than air or a fluid leak.
Checking steering and controls during a haul-out? See the haul-out inspection checklist. Problem is the drive itself rather than the controls? See sterndrive repair.
Steering or shifting not right
Text a photo of the helm or shift lever and describe exactly what it's doing.
